Announcement

Collapse
No announcement yet.

0-10 Analog Out

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Todd Dice
    replied
    Just be careful if you're plan on using the Click with current/voltage output. Those combo units ONLY provide 0-5V, instead of 0-10V. If you want to use 0-10V, you have to go with an analog voltage only output Click.

    Leave a comment:


  • ekcourter
    replied
    Your help is appreciated, Ed Courter

    Leave a comment:


  • quaizywabbit
    replied
    yes the DF location of your output can be manipulated as you see fit once youve setup the range and scaling in the system configuration

    Leave a comment:


  • ekcourter
    started a topic 0-10 Analog Out

    0-10 Analog Out

    Hi, I plan on using a Click 0-10V analog output module to control the speed of a DC motor with an IronHorse Gsd1 series Controller. My quick review of the 2.51 program indicates I can set the speed based on an input with a table of values. Can the output (0-10V) be controlled by values directly written into the program? I only need to know if it is possible, I can do the legwork. I assume it would also work the same, if I used the 1-20 ma inputs used on some DC controls? Thanks
Working...
X